Grohe Veris F-digital 36 277 Mode D'emploi page 9

Operation of the digital controller, see fold-out page II, Fig. [6].
Button Description
Start/Stop button
Starts and stops the water flow at the saved water temperature and
flow rate.
Pause button
Interrupts the flow of water. The flow is resumed with the last selected
settings by pressing the button again within 30 seconds.
Temperatures above 42 °C are not saved.
Temperature buttons
Start the water flow and decrease or increase the water temperature.
Display when maximum temperature is reached
Display when minimum temperature is reached
Exceeding the safety stop
42 °C
When the safety stop is reached (factory setting 42 °C), press button
for 1 second, release and then press again for 1 second.
Set flow rate
Turning clockwise starts the fitting and increases the flow rate.
Turning anti-clockwise reduces the flow rate until the fitting switches to
pause mode.
Memory function
The current temperature and flow rate can be saved when the water is
running by pressing and holding the button. Temperatures above 42
°C are not saved.
Cleaning service mode
If no water is flowing, pressing and holding both buttons
simultaneously activates cleaning service mode for 2 minutes.
The buttons have no function within cleaning service mode.
The flow can be interrupted within the 2 minute period by pressing
and holding both buttons simultaneously.
Visualisation
The temperature is represented by the
illuminated ring.
The temperature is represented by the
illuminated ring.
Illuminated ring flashes red 3x
Illuminated ring flashes blue 3x
Illuminated ring flashes 3x when the safety
stop is reached in the colour of the set
temperature
Modification of flow rate
Illuminated ring flashes green 3x and water
flow is interrupted briefly
Illuminated ring flashes violet 3x
Illuminated ring flashes violet 1x when
actuated
Illuminated ring flashes violet 3x
6