R&G CP0280 Guide Rapide page 3

Nearside (left side as you sit on the bike)

Remove side fairing.

Remove engine bolt in position arrowed in picture ONE.

Take a length of self-adhesive foam and stick to inside face and sides (that wrap around the frame) of
mounting block (M0272) and trim to size, this helps prevent marking the frame.

Place the M10x75mm long hex head bolt with washer through the slot in the mounting block (M0272).

Offer this assembly up to frame as shown in picture ONE and tighten bolt to no more than 40Nm torque.

Take a length of self-adhesive foam and stick to face of the clamp (F0030) (the face that will sit against the
frame) and trim.

Place the clamp behind frame and using two of the M6 cap head bolts through the mounting block (M0272)
secure and tighten.

Refit side fairing ensuring the mounting block assembly does not distort the fairing.

Take the hex headed M10x60mm long bolt and place one of the plain washers up to the head of bolt followed
by a shake proof washer (LW0001).

Pass the bolt assembly through the longer crash protector so bolt head and washers go into the counter-bore.

Install the crash protector assembly onto the mounting block, ensuring that the crash protector is aligned with
the aero shaped spigot, Note the larger diameter of the protector faces towards the front of the bike as shown in
picture THREE.

Tighten bolt until you feel some compression from inside the protector. Turn a little more so that you feel the
compression increase slightly. Then apply a quarter turn. Do not over tighten as damage can occur to the
bike. Do not exceed 40nm of torque.

When happy that everything is correct, place the blanking cap into the end of the protector.
Offside (right side as you sit on the bike)

Remove side fairing.

Remove engine bolt in position arrowed in picture TWO.

Take a length of self-adhesive foam and stick to inside face and sides (that wrap around the frame) of
mounting block (M0273) and trim to size, this helps prevent marking the frame.

Place the M10x70mm long hex head bolt with washer through the slot in the mounting block (M0273).

Offer this assembly up to frame as shown in picture TWO and tighten bolt to no more than 40Nm torque.

Take a length of self-adhesive foam and stick to face of the clamp (F0030) (the face that will sit against the
frame) and trim.

Place the clamp behind frame and using two of the M6 cap head bolts through the mounting block (M0273)
secure and tighten.

Refit side fairing ensuring the mounting block assembly does not distort the fairing.

Take the hex headed M10x45mm long bolt and place one of the plain washers up to the head of bolt followed
by a shake proof washer (LW0001).
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email:
3
info@rg-racing.com