CLAS AC 0530 Mode D'emploi page 7

AC 0530
50-160mm DRILLING INSPECTION DEVICE SET
SPECIFICATIONS
Measuring range
6 - 10 mm
10 - 18 mm
18 - 35 mm
35 - 50 mm
50 - 100 mm
50 - 160 mm
160 - 250 mm
250 - 450 mm
WARNINGS
• Do not disassemble or modify the gauge
• Do not hit the gauge
• Clean and apply rust inhibitor after each use and disassembly of the gauge (leaving the
gauge assembled to the rod may result in inaccurate future measurements), then place
the gauge in the housing.
• Do not use the extensions, seals or components for any purpose other than those
specifi ed in this manual.
Depth measurement
40mm
100mm
150mm
150mm
150mm
150mm
400mm
400mm
• In order to obtain accurate data, it is
generally recommended to measure several
positions, see the fi gures on the left.
Pins Seal
9
9 1
9 2
4 4
11 4
12 4
5 5
5 5
Component
1
1
2