CLAS AC 0530 Mode D'emploi page 5

AC 0530
50-160mm DRILLING INSPECTION DEVICE SET
DESCRIPTION
Measuring
Holder
instrument
ASSEMBLY
Grip Screw
127 mm
1. Mounting the gauge
• Insert the gauge rod into the holder.
• The gauge indicator pointer rotates about 1 turn
• Lock the gauge with the screw.
2. Installation of pins or joints
• Remove used pins and/or seals
• Install the appropriate component and seal by selecting
the correct part number (see table below).
• Tighten the fi xing nut tightly.
Locking
nut
Gauge
Pins
Seal
Point of
Guide
contact