ShelterLogic 26'W x 12'H Peak Shelter Manuel D'assemblage page 12

11. INSTALLING THE COVER ON THE FRAME - continued
H. At the corners, insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle
of the ratchet and pull tight. Wind the ratchet so that the webbing overlaps itself. See Figure 11G.
I. Repeat these steps on the opposite side, then repeat this on the back side of the shelter.
J. Adjust the cover front to back so that it is centered. Install the bottom cover rails (#802051 and #802050) by
inserting them into the pipe pockets on each side of the cover. An opening allows the webbing to wrap around
cover rail and base rail to secure the cover. Tighten webbing using ratchet as shown in Figure 11J
k. Tighten all of the ratchets. Do this in an "X" pattern to be sure it is tightened evenly.
Fig.11G
Thread
Webbing
Into
Ratchet
NOTE: CHECk THAT YOUR COVER IS CORRECTLY PLACED ON THE FRAME.
The ShelterLogic logo should line up on the left front and right rear corners. If the logo does not read correctly, the cover
®
has not been put on the frame correctly.
INCORRECT
Cover Tightening Tip
Check and
tighten Ratchets
and Cross Rails
monthly to ensure
the cover is tight.
CORRECT
ASSEMBLED
COvER RAIL
TIGHTEN COvER DOWN
WITH RATCHET, STARTING
AT ONE END WORKING TO
OPPOSITE END ON BOTH
SIDES.
Webbing
and
Ratchets
Securing
Cover
Page 12
Fig.11H
Fig.11I
Fig.11J
05_10A153_D6