Channel Set-Up - Sony Bravia KDL-46R470A Mode D'emploi

Channel Set-up

Analogue Set-up
32
GB
"Analogue Auto Tuning"
Tunes in all the available analogue channels.Usually you do not need to do this
operation because the channels are already tuned when the TV was first
installed. However, this option allows you to repeat the process (e.g., to retune
the TV after moving house, or to search for new channels that have been
launched by broadcasters).
"Manual Programme Preset"
Before selecting "Label"/"AFT"/"Audio Filter"/"Skip"/"Colour System", press
PROG +/– to select the programme number with the channel. You cannot
select a programme number that is set to "Skip" (page 32).
"Programme"/"TV System"/"Frequency"
Presets programme channels manually.
1
Select "Programme", then press
F f
2
Press / to select the programme number you want to manually tune
(if tuning a VCR, select channel 0), then press RETURN.
F f
3
Press / to select "TV System", then press
F f
4
Press / to go to the frequency range indication ("VHF Low", "VHF High"
or "UHF"), then press
5
Tune the channels as follows:
G g
Press to search for the next available channel. When a channel has been
/
found, the search will stop. To continue searching, press
Repeat the procedure above to preset other channels manually.
"Label"
Assigns a name of your choice, up to seven letters or numbers, to the selected
channel.
To input characters:
F f
1
Press / to select the desired letter or number ("_" for a blank space),
g
then press .
If you input a wrong character
G g
Press / to select the wrong character. Then, press
character.
2
Repeat the procedure in step 1 until the name is completed, then press
"AFT"
Allows you to fine-tune the selected channel manually. When "On" is selected,
the fine tuning is performed automatically.
"Audio Filter"
Improves the sound of individual channels when distortion occurs in mono
broadcasts in TV system "B/G", "I" and "D/K".
• You cannot receive stereo or dual sound when "Low"/"High" is selected.
"Skip"
Skips unused channels when you press PROG +/– to select channels. (You
can still select a skipped channel using the number buttons.)
"Colour System"
Selects the colour system ("Auto", "PAL", "SECAM", "NTSC3.58", "NTSC4.43"
or "PAL60") according to the channel.
.
.
.
G g
/ .
F f
/ to select the correct
.