Assembly; General Description; Wall-Mounted Assembly - Tuxhorn tubra-PGM-S DN 20 Instructions De Montage Et D'utilisation

4 A s s e m b l y
4.1

General description

The heating circuit station can be installed and operated in many different installation posi-
tions, provided that the pump shaft is horizontal.
4.2

Wall-mounted assembly

14
Art.-Nr. 968.20.27.00
Last updated 2022/02/28
Remove securing springs [3].
Lift the flow and return lines and
remove them from the
mounting angle [14].
Remove the rear insulation shell.
Mark attachment points of the
mounting angles [14].to the wall
and drill two ø10 mm holes.
Place the dowel and tighten the
mounting bracket [14] with the
screws and washers.
Align mounting bracket [14] hori-
zontally.
Slide rear insulation shell onto
mounting bracket [14].
Insert flow and return line in the
mounting angle and secure with
the locking springs [3].
- 7 -
GB