Witter HN62AQ Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 1 Left Sidearm
C 1 Right Sidearm
D 2 Spacers (40 O.D, 23 Long)
G 4 M12x35x1.75 Bolts, Nuts, Lock Washers, Flat Washers and 8 off Bolt Caps.
H 1 M16x100x2.0 Bolt, Nut, Lock Washer and 2 off Bolt Caps.
K 4 M12 Bolt Caps.
L 8 M10x40x1.25 Bolts, Lock Washers and Flat Washers 25mm O.D.
ZE 1 Electrical Plate (ZEP3).
ZQ 1 Detachable Neck (ZQ2042)
X 1 M6x20x1.0 Bolt, Nut, Lock Washer and 2 off Flat Washers.
FITTING
1. Remove under tray, 3 off bolts on lower edge, 1 spring nut on lower edge and 1 off self tapping screw in left hand wheel
arch. Note: under tray is not refitted. Lower exhaust.
2. Loosely attach sidearms (B) & (C) to captive nuts in lower faces of chassis rails using fixings (F). It may be necessary to
trim lower edge of bumper to allow left sidearm to pass.
3. Loosely attach crossbar (A) to sidearms (B) & (C) using fixings (G).
4. Insert spacers (D) around towing eye and secure using fixing (H) Fully Tighten.
5. Attach Detachable Neck as per separate fitting instruction and electrical plate (ZE).
6. Re-attach exhaust and bumper edge. Note replace spring nut from lower edge of bumper with fixing (X) and re-fit self
tapping screw in left hand wheel arch by putting clip from under tray onto vehicle body.
Note:
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY Tel: 01244 284500 Fax: 01244 284577
W0001HN62AQ-FIT$0210030900007Ä
W 0001HN62AQ-FIT$021003090000
TOWBAR
HN62AQ
For HONDA CR-V
2007-
Issue 1