Witter HN62B Notice De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 1 Left Sidearm
C 1 Right Sidearm
D 2 Spacers (40 O.D, 23 Long)
F 1 Neck Assembly
G 4 M12x35x1.75 Bolts, Nuts, Lock Washers, Flat Washers and 8 off Bolt Caps.
H 1 M16x100x2.0 Bolt, Nut, Lock Washer and Bolt Caps.
K 6 M12x35x1.75 Bolts, Nuts and Lock Washers.
L 8 M10x40x1.25 Bolts, Lock Washers and Flat Washers 25mm O.D.
ZE 1 Electrical Plate (ZEP3).
CB 2 M16x50x2.0 Coupling Bolts, Nuts, Lock Washers and Bolt Caps.
X 1 M6x20x1.0 Bolt, Nut, Lock Washer and 2 off Flat Washers.
FITTING
1. Remove under tray, 3 off bolts on lower edge, 1 spring nut on lower edge and 1 off self tapping screw in left hand wheel
arch. Note: under tray is not refitted. Lower exhaust.
2. Loosely attach sidearms (B) & (C) to captive nuts in lower faces of chassis rails using fixings (F). It may be necessary to
trim lower edge of bumper to allow left sidearm to pass.
3. Loosely attach crossbar (A) to sidearms (B) & (C) using fixings (G).
4. Insert spacers (D) around towing eye and loosely secure using fixing (H) Insert neck (F) between crossbar profiles and
secure using fixings (K) with Electrical Plate (ZE) in position shown. Fully Tighten.
5. Re-attach exhaust and bumper edge. Note replace spring nut from lower edge of bumper with fixing (X) and re-fit self
tapping screw in left hand wheel arch by putting clip from under tray onto vehicle body.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS Deeside Ind. Park, Deeside, CH5 2NY Tel: 01244 284500 Fax: 01244 284577
W0001HN62B-FIT$011103150000ÌÄ
W0001HN62B-FIT$011103150000
TOWBAR
HN62B
For HONDA CR-V
2007-
Issue 1