Witter HN70U Notice De Montage

MATERIALS
A 1 Crossbar
C 1 Left Sidearm
D 1 Right Sidearm
E 2 Bushes (41mm O.D, 20mm Long) & M16 Washers
F 4 M12 x 35 x 1.75 Bolts, Lock Washers, Cage Nuts, Cage Nut Retainers and Flat Washers (30mm O.D)
G 4 M12 x 35 x 1.75 Bolts & Nyloc Nuts
H 4 M8 x 30 x 1.25 Bolts, Lock Washers and Flat Washers (25mm O.D)
J 1 M16 x 100 x 2.0 Bolt, Washers & Nyloc Nut
ZE 1 Electrical plate
ZN 1 Neck Option
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball, which
dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
FITTING
1. Remove the mud flaps (only on certain models). One off screw on outer edge of wheel arch, 1 off plastic push clip on
inner edge of wheel arch and 1 off plastic screw on under section.
2. Remove the Bumper. Six off plastic push clips along lower edge & 4 off hex head screws under plastic covers in boot
opening. Loosen outer wheel arch trims and remove 1 off plastic push clip and 1 off screw securing the bumper. Ease
the bumper out sideways beginning at the wheel arch and then slide bumper rearwards.
3. Remove the crash beam by removing 6 off fixings. Re-fit lowest bolt fixing to protect exposed thread. (Note: Hand
crash beam and remaining fixings to the customer for re-fitting if the towing bracket is removed).
4. Loosely attach the Sidearms (C & D) using fixings (F & H).
5. Attach Crossbar (A) to the Sidearms using fixings (G). Use fixings (J) along with bushes & washers (E) to loosely
clamp around the towing eye. (Note: Mount neck housing between the centre profiles before tightening fully).
6. Fully tighten all fixings to recommended torque settings.
7. Cut bumper.
8. Attach the chosen Neck (ZN) and Electrics Bracket (ZE).
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M12 - 80 Nm, M16 - 200 Nm
Fitting
Instructions
µW0001HN70U-FIT$011404100000FÄ
W0001HN70U-FIT$011404100000
TOWBAR
For Honda Civic Tourer 2014 -
HN70U