Witter HN68U Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
C 1 Left Sidearm
D 1 Right Sidearm
E 2 Bushes (41mm O.D, 24mm Long)
F 4 M12 x 35 x 1.75 Bolts, Lock Washers Cage Nuts, Cage Nut Retainers and Flat Washers (40mm O.D)
G 4 M12 x 35 x 1.75 Bolts, Nuts, Lock Washers and Flat Washers (25mm O.D)
H 4 M8 x 30 x 1.25 Bolts, Lock Washers and Flat Washers (25mm O.D)
J 1 M16 x 100 x 2.0 Bolt, Nut & Lock Washer.
ZE 1 Electrical plate.
ZN 1 Neck Option.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball, which
dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
FITTING
Remove mud flaps (only on certain models) 1 off screw on outer edge of wheel arch, 1 off plastic push clip on inner
1.
edge of wheel arch and 1 off plastic screw on under section.
Remove Bumper, 6 off plastic push clips along lower edge, 4 off hex head screws under plastic covers in boot opening.
2.
Loosen outer wheel arch trims and remove 1 off plastic push clip and 1 off screw securing bumper. Pull bumper out
sideways at wheel arch and then slide bumper rearwards.
Remove crash beam, 6 off fixings and remove beam. (Note: Hand crash beam to final user for refitting if towing bracket
3.
is removed)
Loosely attach Sidearms (C&D) using fixings (F&H).
4.
Attach Crossbar (A) using fixings (G&J) with bushes (E) in position to clamp around towing eye using fixing (J).(Mount
5.
housing in centre profiles before tightening). Fully Tighten all Fixings.
Cut bumper .
6.
Attach chosen Neck .
7.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
W0001HN68U-FIT$011205140000jÄ
W 0001HN68U-FIT$011205140000
TOWBAR
For Honda Civic 5 door 2012-
HN68U