Witter HN66AU Notice De Montage

MATERIALS
A 1 Crossbar
D 1 Right Side-arm
E 1 Left Side-arm
F 2 Spacers
G 2 Bushes (32 O.D x 12 Long)
H 4 M8 x 30 x 1.25 Bolts, Lock Washers and Flat Washers (25 O.D)
J 4 M10 x 30 x 1.5 Bolts, Lock Washers and Flat Washers (30 O.D)
K 4 M12 x 35 x 1.75 Bolts, Lock Washers and Flat Washers.
L 1 M16 x 100 x 2.0 Bolt Nut and Lock Washer.
M 4 M12 Bolt Caps.
ZE 1 Electrical Plate (ZEP3).
ZQ 1 Detachable Neck (ZQ2008)
FITTING
Remove Bumper, 3 off tip screws in each wheel arch, 2 off tip screws along bottom side, 3 off plastic push clips along
1.
bottom edge and 1 off on saloon, 2 off on estate, hex head screws each side of boot opening hidden under plastic cap.
Pull bumper rearward.
Remove crash beam and hand to end user. Lower exhaust and remove heat shield.
2.
Loosely attach crossbar (A) to rear panel using fixings (H).
3.
Trim under tray around centre profiles.
4.
Insert sidearms (D) and (E) into chassis ends and loosely attach to chassis using fixings (J). Secure crossbar to
5.
sidearms using fixings (K).
Attach crossbar (A) to towing eye, with packers (F) and (G) in position shown using fixing (L).
6.
Fully Tighten all fixings.
7.
Cut bumper as shown and re-fit.
8.
Attach neck and electrical plate as per separate instruction.
9.
Recommended torque settings: Grade 8.8 bolts: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214
Nm Grade 10.9: M12 – 139Nm, M10 – 78Nm
Fitting
Instructions
W0001HN66AU-FIT$0111011200003Ä
W 0001HN66AU-FIT$011101120000
For Honda Accord 2008 -
Estate & Saloon
For use with ZQ2008 Detachable
TOWBAR
HN66AU