Witter PG58U Notice De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 1 Z99 Flip up electrical kit.
C 1 ZEQ 4 Electrical plate angle bracket.
D 1 Side Arm Right
E 1 Side Arm Left
F 8 M8 X 35 X 1.25 mm Bolts (10.9 grade), Lock washers and 8 flat washers (25 mm OD)
G 1 M10 X 35 X 1.50 mm Bolts, Lock washers and 1 Flat washers (25 mm OD)
H 4 M10 X 35 X 1.50 mm Bolts, Flat washers (25 mm OD) and Nyloc Nuts.
J 1 M10 X 50 X 1.50 mm Bolts, Lock washer and 1 Flat washer (25 mm OD)
K 1 Z50 Flip Up assembly only on ZQ application
Recommended torque settings: Grade 8.8 bolts: M10 - 52 Nm, M12 - 80 Nm, M16 - 200 Nm Grade 10.9: M8- 35Nm
FITTING
Bumper removal
1. Open boot, unclip inner boot covers to obtain access to rear lights. Disconnect and remove rear light clusters: x1 plastic
nut behind each light cluster. This will expose 1 screw from bumper to car, remove on both sides.
2. Undo 2 arch screws and 1 tip screw each side. Fold back inner arch cloth to expose 1 torx each side. For reversing
sensors unplug the connection found under the offside rear.
3. Remove 2 screws under bumper and 1 nut. Pull tips outwards by releasing clips and push downward clips between boot
seal and bumper. Pull bumper away.
Fitment of Cross bar
4. Above crash beam remove black plastic tray and keep for refitting. Remove crash beam and retain for customer. Fit part
(A) to the rear panel and finger tighten using fasteners (F).
5. Fit right side arm (D) using bolt (G) to outside chassis rail and allow to swivel. Note: Captive holes are covered in tape.
Rotate side arm up to part (A) end profiles and fix using fasteners (H).
6. Connect side arm (E) to cross bar (A using fasteners (H). Complete side arm (E) using bolt (J) to outside chassis rail.
Note: Bolt (J) is longer for the bush on the exhaust side.
7. Once all aligned tighten remaining bolts to their recommended torque
8. Refit black plastic trim and bumper ensuring upper tips align, refit all the screws that were removed and ensure the reverse
sensor plug is reconnected.
9. Attach preferred neck and electrical plate bracket (C) to the centre profiles. Attach the Z99 flip up kit and as option cut
bumper should the electrical socket require it.
10. Fully tighten all remaining fixings to the recommended torque setting.
W0001PG58U-FIT$011107080000WÄ
W0001PG58U-FIT$011107080000
For Peugeot 508 Estate SW 2011 -
For use with 3008 series necks
TOWBAR
PG58U