Replacement Parts; Replacing The Spark Plug - PROPOINT D2300iS Mode D'emploi

8953150
4. Afterburning (backfiring).
5. Black exhaust smoke or high fuel consumption.

REPLACEMENT PARTS

The emission control systems on the engine is designed, built and
certified to conform to Canadian emission regulations. Genuine parts
are recommended when servicing the engine. Genuine replacement
parts are manufactured to the same standards as the original parts.
Using replacement parts that are not of the original design and quality
may impair the effectiveness of the emission control system.
It is the responsibility of the aftermarket part manufacturer to certify that
the part will not result in a failure of the engine to comply with emission
regulations.

REPLACING THE SPARK PLUG

NOTICE! Using an incorrect spark plug can cause engine
damage. Only replace a spark plug with a model
recommended by the manufacturer.
The spark plug must be properly gapped and free of deposits for the
best performance. Check local bylaws to see if a resistor spark plug is
required to suppress ignition signals. Replace the included spark plug
with a resistor spark plug if required.
1. Remove the Spark Plug Cover and set aside.
2. Remove any dirt from around the spark plug area.
3. Unclip the spark plug lead and remove the spark plug with a spark
plug wrench. This will have a rubber pad inside the socket to
protect the spark plug's ceramic coating.
4. Inspect the spark plug. Replace it if damaged, badly fouled, the
sealing washer is in poor condition or the electrode is worn.
Assistance available at www.princessauto.com or 1-800-665-8685
GASOLINE INVERTER GENERATOR V1.0
Page 24