Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
ADJUSTING THE ENGINE IDLE SETTING
NOTICE! The engine speed is set by the factory. Increasing
the speed too much can damage the engine. Too low a
speed will reduce the engine's efficiency. Have a qualified
technician adjust the engine speed if necessary.
The engine's idling speed is adjustable by turning the governor arm
screw to lower or increase the engine output (RPMs).
1.
Remove the shroud and locate the governor arm screw.
2.
Start the engine and wait for it to idle.
3.
Tighten the screw to increase the engine speed. Loosen to reduce
speed.
4.
Shut the engine off and allow to cool.
EMISSION CONTROL SYSTEM
INFORMATION
The combustion process produces carbon monoxide, hydrocarbons
and nitrogen oxides. Controlling these emissions is important for
personal and environmental health.
The following instructions must be followed in order to keep the
emissions from your engine within Canadian emission standards.
1.
Do not remove or alter any part of the intake, fuel or exhaust
system.
2.
Do not alter or bypass the governor linkage or a speed-adjusting
mechanism that force the engine to operate outside its design
specifications.
PROBLEMS THAT MAY AFFECT EMISSIONS
Have your engine inspected and repaired by a qualified technician if
you are aware of any of the following symptoms.
1.
Hard starting or stalling after starting.
2.
Rough idle.
3.
Misfiring or backfiring under load.
Page 23
GASOLINE INVERTER GENERATOR
Assistance available at www.princessauto.com or 1-800-665-8685
8953150
Publicité
Table des Matières
