Ac Parallel Operation - PROPOINT D2300iS Mode D'emploi

8953150
5. Calculate the power draw of all devices, including the peak
wattage, to make sure you are not exceeding the generator's
power capacity.
6. Restart the engine and follow the steps for running the generator.
ENGINE ECO CONTROL
1. Push the ECO toggle switch to activate the economy control unit.
The engine speed will increase or decrease based on the power
needed for the electric load. This improves fuel economy and
reduced engine noise.
2. When the ECO switch is in the OFF position, the engine will run at
the maximum rated speed (see Specifications).
3. The ECO switch must be turned to the OFF position when using
electronic devices that require a large starting current, such as a
compressor.

AC PARALLEL OPERATION

WARNING! Do not connect or disconnect the parallel cables
when the generators are running to avoid an electric shock.
The parallel outlets allow you to connect two inverter generators
together to increase the power output. This requires a parallel cable kit
(sold separately).
Both generators must be the same make and model.
1. Connect the two generators together with the parallel cables,
matching the parallel port polarity.
2. Make sure the ECO switch is set to the same position on both
generators.
3. Disconnect all electronic devices from the generators prior to
starting them.
4. Start each generator's engine.
5. Wait for each engine to stabilize before plugging in the first
electronic device into the AC receptacle (starting with the largest
wattage item). Turn the device on and wait for the output to
stabilize.
Assistance available at www.princessauto.com or 1-800-665-8685
GASOLINE INVERTER GENERATOR V1.0
Page 12