Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Do not use special additives
4.
SAE 10W-30 is recommended for
general, all-temperature use.
Other viscosities shown on the
chart may be used when the
average temperature in your area
is within the indicated range.
5.
Using 10W-30 oil when the
temperature is above 27°C (80°F)
may increase oil consumption .
Check the oil level more often.
6.
Starting the engine will be more difficult when using SAE 30 oil
below 4°C (40°F).
HOW TO CHECK OIL
1.
Level the engine or the equipment the engine is mounted on.
2.
Remove the Oil Maintenance Cover to access the oil dipstick.
3.
Clean the oil fill area of any dirt and debris to prevent
contamination that can damage the engine.
4.
The engine has a dipstick that is either
part of the oil fill plug or a separate
component.
a.
Remove the dipstick and wipe with a
clean cloth.
b.
Reinsert the dipstick into the filler
neck until it rests on the opening's
rim. Do not screw the oil fill plug back
into the opening.
c.
Remove the dipstick and check that the oil is between the Full
and Fill marks. Add or drain oil based on the measurement
d.
Reinsert the dipstick and either press firmly to hold in place or
screw the oil fill cap hand tight.
5.
Replace the side panel and secure.
Page 19
GASOLINE INVERTER GENERATOR
Assistance available at www.princessauto.com or 1-800-665-8685
8953150
Fig. 1
Fig. 2
Publicité
Table des Matières
