PROPOINT D2300iS Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8953150
HOW TO ADD OIL
1.
Place a funnel into the oil fill neck. The funnel opening should be
wide enough to prevent the oil from collecting in the funnel's cone.
2.
Pour oil into the funnel. Allow the oil to settle for one minute and
recheck the level. Repeat until the desired level is reached.
3.
Insert the oil filler cap and hand tighten.
4.
Wipe up any spilled oil. Dispose of oil soaked rags in a proper
hazardous waste container.
5.
Reattach the side cover. Secure cover with each screw.
6.
Reinstall the Oil Maintenance Cover.
IMPORTANT! Used oil must be disposed of properly. Do not
pour it on the ground, down a drain or throw it in the trash.
Take the oil to your local recycling centre or a service
station for reclamation.
HOW TO DRAIN OIL
1.
Run the generator for several minutes to warm the oil. Turn the
generator off.
2.
Remove the Oil Maintenance Cover to access the oil dipstick.
3.
Remove the dipstick.
4.
Place an approved container
below the oil drain plug.
5.
Tilt the generator to pour the used
oil out of the dipstick opening.
IMPORTANT! Used oil must be
disposed of properly. Do not pour it on the ground, down a
drain or throw it in the trash. Take the oil to your local
recycling centre or a service station for reclamation.
SERVICE THE AIR FILTER
NOTICE! Operating the engine with a damaged or missing
air filter will allow dust and debris to enter the engine,
causing rapid engine wear or scoring on the engine pistons.
Always ensure the air filter is in place.
Assistance available at www.princessauto.com or 1-800-665-8685
GASOLINE INVERTER GENERATOR
V1.0
Fig. 3
Page 20

Publicité

Table des Matières
loading

Table des Matières