Elem Garden Technic TDE40V37-LI2BF Traduction D'origine page 48

TROUBLESHOOTING
The following chart lists problem symptoms, possible causes and corrective action, if your machine does not
operate properly. If these do not identify and correct the problem, contact your service agent.
● Warning: Switch off and remove the isolator key before investigating fault
Problem
The machine does not
work
Machine start,
immediately stop
Machine functions
intermittently
Machine leaves ragged
finish and/ Motor labor
Area of cut (battery
duration) not large
enough
Cutting blade not
rotating while machine
switched on
Excessive
vibrations/noise
No charging procedure
possible
The charge control LED
respectively, do not light
up after inserting the
mains plug into the
socket
Possible Cause
Possible clogging
Battery not fully charged
Battery not inserted (properly)
Grass too long
Isolator damage
Motor protector has activated
Battery too hot/cold
Isolator key not inserted
correctly/fully
There is a short delay in the motor
starting after engaging the switch
lever
Battery not fully charged
Isolator key not inserted
correctly/fully
Battery not inserted (properly)
Battery too hot/cold
Internal wiring of machine
damaged
Motor protector has activated
Height of cut too low
Cutting blade dull
Possible clogging
Blade fitted upside down
Height of cut too low
Grass too high
Grass wet or damp
Grass is dense
An additional battery can be
purchased from an authorized
customer service agent for garden
products
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade damaged
Battery contacts contaminated
The battery is defective, due to a
disconnection in the battery
Mains plug of battery charger not
plugged in (properly)
Socket outlet, mains cable or
battery charger defective
Corrective Action
Check underneath the machine and clear out as
necessary (always wear gardening gloves)
Battery Charging
Inserting the Battery
Increase height of cut and tilt machine to reduce
starting load
Contact Service Agent
Allow motor to cool /increase height of cut
Allow to cool/warm
Fit correctly
Hand switch lever for 1–3 s to start motor
Battery Charging
Fit correctly
Inserting the Battery
Allow to cool/ Increase height of cut
Contact Service Agent
Allow motor to cool /increase height of cut
Increase height of cut(see "Adjusting the Cutting
Height")
Replacing the blade(see "Blade Maintenance")
Check underneath the machine and clear out as
necessary (always wear gardening gloves)
Refit blade correctly(see "Blade Maintenance")
Increase cut height and walk slower
Increase cut height and walk slower
Wait until grass is dry and walk slower
Increase cut height , walk slower and cut more
frequently
Contact Service Agent
Switch off machine Clear obstruction (always
wear gardening gloves)
Tighten blade nut/bolts
Tighten blade nut/bolts
Contact Service Agent Replacing the blade
Clean the battery contacts (e.g. by inserting and
removing the battery several times) or replace
the battery（Batteries can be purchased to
service agents）
Replace the battery（Batteries can be
purchased to service agents）
Insert mains plug (fully) into the socket outlet
Check power supply voltage, if necessary, a
battery charger, an authorized inspection station
contact customer service