Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Burgundy
¤ At least once a year / End of heating season : Clean
or replace all the oil filters in the oil supply line.
To clean the filter of the float regulator :
- set the regulation knob in closed position "0",
- turn off the tankvalve or the valve of the oil supply line,
- raise the safety lever of the float regulator,
- place a small container (or a small rag) under the regula-
tor filter opening in order to collect the oil contained in the
regulator,
- remove the filter cover plate located under the regulator
(# 4, ill. 9, page 19) with a screwdriver,
- remove the tubular filter from the regulator. Clean, if ne it
3.7. Trouble shooting
Situation
Flames extinguish during
lighting.
Fire extinguishes once
firestarter has burnt off.
Fire extinguishes during use.
Flame is excessely large,
smokey and sooty.
Stove burns noisily,
extinguishes and relights itself.
Fire smokes.Soot build up
noticed. Flame imbalance
20
Cause
¤ Ver y cold chimney. No draft
established.
¤ Fuel tank is empty.
¤ Fuel valve is closed.
¤ Main regulator float not engaging.
¤ Control knob is set on "0"
¤ Fuel tank is empty.
¤ Insufficiant draft.
¤ Fuel adjustment made too quickly.
¤ Burner contains excess fuel.
¤ Insufficient fuel.
¤ Insufficient air supply.
¤ Downdraft or blockage in chimney.
¤ Oil flow is too low on 1 setting.
¤ S t ove is not level. Flame
imbalance.
¤ Catalyser not centered. Uneven
f uel dist ribution resulting in
secondary air shortage.
Document n° 809-5EN ~ 15/04/1999
with oil using a soft brush, never a wire-brush,
- replace the filter in the regulator, install the cover plate
and secure with the screw.
¤ Clean all the enamelled panels of the stove with a dry or
slighly damp soft cloth.
¤ Use a soft clean cloth to wipe the front glass when the
unit is running at a low burning rate. When the main door
is opened for cleaning, the flame will be disturb, and turn
to a yellow flame. Clean quickly, but gently. Close the door,
the flame will return to a normal burning position.
þ
: This sign means that you should
asked for a qualified engineer to do
Action
- Leave door ajar until fire has caught.
- Check air supply in the room.
- Fill tank.
- Open valve.
- De-press the safety lever.
- Adjust control knob to "1".
- Fill tank.
þ
- Call your installer.
- Return control knob to "1"; wait for normal combustion.
(catalyser should glow red) Wait 5 to 15 minutes between
each adjustment.
þ
- Adjust to lower setting. If problem persists call your
installer.
- Check that the de-scaler, the regulator filter and burner
pot are cleaned.
- Increase fresh air supply (open door, window; add make
up air supply).
þ
- Check Chimney for Soot build up. clean if necessary.
- Ensure chimney height is sufficient and cap is not
affected by any nearby obstructions.
- Room is in negative pressure. Increase fresh air supply.
Check draft with draft meter and adjust if not to
requirements.
See page 15.
þ
- Adjust low flow rate while control is set on "1", call your
installer.
- Check level. Adjust if necessary.
- Center catalyser assembly
Oil burning stove
the work.
Technical manual
Publicité
Table des Matières
