Chimney Draught; Maintenance Of The Chimney - FRANCO BELGE Bourgogne 174 10 25 Notice De Référence

Burgundy
setting screw # 3 counter clock-wise.
- If the flame is too high ; reduce the flame by turning the
setting screw clock-wise.
Please note - Very important : The adjustments of the
float regulator are very sensitive. The hight and the low
setting screws must never be turned more than a 1/4 of a
turn at a time in any direction from their initial setting.
When making any adjustments, allow 3 to 5 minutes be-
tween adjustments to allow burner to stabilize to previous
adjustment before proceeding, if necessary.

2.10. Chimney draught

Once the stove has been properly installed, the chimney
draught must be checked.
The adjustment of the draught can be made with the
barometric damper located at the back of the stove
(# 1, ill. 8).
The reading of the draught must be done once the unit is
hot (minimum 30 minutes of use).
Refer to the specifications page 15 for minimum draught
requirement on mini setting and on maxi setting.

2.11. Maintenance of the Chimney

Chimney and chimney connector should be inspected at
least once every three months during the heating season
to determine if a soot build up has occurred. If soot has
accumulated, it should be removed to reduce the risk of a
chimney fire.
O n c e o r t w i c e a y e a r : Remove the flue baffle
(# 23, ill. 10, page 2 2 ) . F i r st r e m o v e t he t op p late
(2 screws, one on each side of the stove).
18
1
1 - Adjustment of the draft regulator
2 - Adjustment screw for mini setting
3 - Adjustment screw for maxi setting
Document n° 809-5EN ~ 15/04/1999
2
Ill. 8 - Operating devices
Oil burning stove
3
Technical manual