Tools Required For Assembly - Craftsman 919.670281 Guide De L'utilisateur

Tools Required for Assembly

Adjustable wrench
5 mm Allen wrench (supplied)
Remove Pressure Washer from Carton
Open carton from the top. Locate and remove from
•
box the handle, gun, wand, chemical hose, oil
parts bag.
Cut carton along dotted lines.
•
Remove all carton inserts.
•
Roll unit through opening in carton.
•
NOTE: The hose is located at the bottom of the
box.
Preparing the Pressure Washer for First Use
Note: Included with your pressure washer is a video
cassette tape on how to prepare your unit for
operation. It is recommended you view this tape before
performing the next steps.
1. Insert handle onto frame.
Insert knobs into the threaded slot in front of
•
the frame handle and tighten by turning in a
clockwise direction.
Slide bolts into the slot in the side of the frame
•
handle and tighten the nuts by turning in a
clock-wise direction.
2. Using an adjustable wrench, remove nut from bolt
that attaches board to frame. Remove wood plank
from the frame of the unit. Discard bolt and board.
D24150
Insert bolt and tighten
lock nut.
Tighten knob in
clockwise direction
6 - ENG
3. Mount the rubber isolator to the frame. To
mount isolator place threaded end of bolt through
the washer.
Next with washer on bolt place threaded end
•
of bolt through the larger hole in bottom of the
rubber isolator.
Place threaded portion of bolt through the
•
same hole location the wood plank was
mounted to on the pressure washer.
Next place the tee nut over the threaded
•
portion of the bolt and use the Allen wrench
provided to tighten isolator to the frame.
TEE NUT
PRESSURE
ISOLATOR
WASHER
FRAME
WASHER
BOLT
4. Connect wand extension to gun. To tighten, turn
knob in clockwise direction. Hand tighten.
5. Remove tie wrap off of high pressure hose. Unwind
high pressure hose and attach the threaded end to
the gun. Tighten with adjustable wrench.
6. Connect high pressure hose to outlet on pressure
washer and hand tighten firmly.
NOTE: Always keep hose away from engine muffler.
HIGH
PRESSURE
HOSE