Intended Use; Assembly And Adjustments - Craftsman CMEPW2100 Guide D'utilisation

English
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
OPM .................... oscillations per
minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.

Intended Use

This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoor furniture.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Specifications
Maximum Pounds per Square Inch
Rated Gallons per Minute*
Electrical Requirements
Electrical Cord
High Pressure Hose
Minimum Amp Source
Pressure of Inlet Water*
Inlet Water
Soap Consumption Rate
*Water flow and maximum pressure ratings determined in accordance with
CETA CPC-100.
4
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
2,100
1.2
120V ~60Hz, 13A
AC
35 ft. (10.6 m)
25 ft. (7.6 m)
15A
20-100 PSI
Cold Tap
10% MAX
Assemble Wheels (Fig. B)
Your pressure washer is not fully assembled in the carton.
1. To assemble the wheels
insert an axle pin 16
nOTE: Follow this process for left and right wheels.
2. With the wheel attached, insert the axle pin
axle bracket 18 and install the retaining pin
in Fig. B to the axle pin
nOTE: Follow this process for left and right wheels.
3. Ensure wheels 15 are fully secured to the
axle bracket 18 .
Fig. B
15
16
17
Assemble Lower Frame kickstand (Fig. C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the lower frame kickstand
21 , align the frame poles
20 so the detent pins
Fig. C
23
Assemble Frame Handle (Fig. D)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle
washer unit 7 , align the upper poles
poles 26 so the detent pins
15 to the pressure washer unit
through the wheel hub 17
16
19
16 until it snaps into place.
7
18
20 to the frame
22 with the kickstand poles
23 snap into position.
21
22
23
20
24 to the pressure
25 with the lower
27 snap into position.
7 ,
.
into the
as shown
19