Recharging The Battery - Aerogen Solo Manuel D'utilisation Du Système

Table 1. Aerogen Pro-X Controls & Indicators
Control / Indicator
30 Min. Indicator
Continuous Indicator
Error Indicator
On/Off Power Button
Battery Status Indicator

Recharging the Battery

To recharge the battery, connect the AC/DC adapter to the controller and
connect to AC power source. The battery status indicator is amber while
charging and green when fully charged.
If the controller is placed in long-term storage, it is recommended that the
battery be recharged every 3 months.
Allow a minimum of four hours for the internal battery to fully recharge.
Aerogen® Solo System Instruction Manual
Function
• Green (steadily lit) = 30 Minute
nebulisation cycle on
• Green (flashing) = Low battery
power
• Nebuliser automatically powers off after
30 minutes have elapsed
• Green (steadily lit) = Continuous
nebulisation cycle on
• Nebuliser does not power off
automatically
• Amber (steadily lit) = Aerogen Solo
nebuliser disconnected from Aerogen
Pro-X Controller
• Amber (flashing) = Aerogen Pro-X drive
voltage error
• To operate in 30 Minute Mode, press the
On/Off button once
• To operate in Continuous Mode, press
and hold the On/Off button for greater
than 3 seconds from off
• Pressing during nebulisation turns off
power to the nebuliser
• Green = Battery fully charged
• Amber = Battery charging
• No light = Battery in operation
13