Ford F-150 Instructions D'installation page 6

1/8"
(12mm)
(3.2mm)
22
Tighten PT-Screws using a T-25 torx driver, starting in the
middle of each upright, then the outer screws and lastly the
remaining two to evenly tighten.
24
NOTE: Pull tailgate release handle to release
buckles from the tailgate.
Before flipping the Bed Extender into the cargo
divider position, secure the buckles/straps on
the top clips while the Bed Extender is outward
position, this is to secure them from swinging.
26
PG 6/8
Top and Bottom
Tubes,
Same on
Opposite Side.
Rivet Gun
1/2"
1/8" Rivet
22 in-lbs
(2.5Nm)
NOTE: Do not over tighten as this
may strip out. Fastener will reach
a noticeable stopping point.
Attach plastic upright around the tube juncture, placing
rubber bumpers into the two ends of the upright.
NOTE: The inside of the upright is
stepped to fit correctly around the
23
small and large diameter tubes.
Adjust Strap Buckles to lock into the tailgate when Bed
Extender is deployed.
NOTE: Ensure that buckles are properly inserted into
latches by pulling on the straps after both buckles have
25
been inserted.
Upright is not positioned
in center of tube joint.