Ford F-150 Instructions D'installation page 3

Position bracket assembly on D-pillar, apply nuts in through the lamp cavity.
Note: Use bracket as marked, passenger side (R) shown below.
6
Holding bolts and bracket assembly in place, hand tighten
nuts (F) to bolt ends in lamp cavity.
7
Using 13mm socket wrench torque top fastener on bracket
holding nut in place in lamp cavity with 13mm box wrench.
9
PG 3/8
MOUNTING BRACKET INSTALLATION
8
Using 13mm socket wrench torque bottom fastener,
holding nut in lamp cavity in place with 13mm box wrench.
10
NOTE: Make
sure nuts
are centered
correctly over
D-pillar hole
inside lamp
cavity.
Torque to
11 Ft-lbs / 15Nm