Table des Matières
Publicité
Utilisation en environnement industriel
Les produits SIMATIC sont conçus pour l'utilisation en milieu industriel.
Tableau 3- 1 Utilisation en environnement industriel
Domaine d'utilisation
Industrie
3.2
Normes et homologations du répartiteur de terrain actif AFD4 (FM)
Homologation FM
Factory Mutual Research (FM) selon
● Approval Standard Class Number 3611, 3600, 3810
● ANSI/ISA 82.02.01 (CEI 61010-1)
● CSA C22.2 No. 213
● CSA 22.2 No. 1010.1
APPROVED for use in Class I, II, III Division 2, Groups A, B, C, D, E, F, G T4;
Class I, Zone 2, Group IIC T4;
Zone 22, AEx tc; IIIC T 80 °C
IP 66 Type 4X
Notes d'installation
1. The AFD4 (FM) (MLFB = 6ES7655-5DX40-1AA1) is only suitable for installation in DIV. 2
/ Zone 2 locations, and is not suitable for installation in DIV. 1 / Zone 1 or Zone 0
hazardous (classified) locations.
2. AFD4 (FM) and all other approved devices in the fieldbus system must be installed in
accordance with the manufacturer's instructions.
3. Replace blank out panels (caps) by UL or CSA approved lead-throughs for connection of
more field devices.Customer has to use a gland and cable "listed for the application"
based on the NEC and CEC. Installations shall comply with the relevant requirements
ofthe National Electrical Code® (ANSI/NFPA-70 (NEC®), where applicable.
4. WARNING FOR APPLICATIONS IN DIV. 2 / ZONE 2 (CLASSIFIED) LOCATIONS:
EXPLOSION HAZARD. EXCEPT FOR SPUR LINES (FIELD DEVICES), DO NOT
CONNECT OR DISCONNECT ANY TRUNK LINE UNLESS THE AREA IS KNOWN TO
BE NONHAZARDOUS.
Répartiteurs de terrain actifs AFD4, AFD4 (FM), AFD8 et AFS
Information produit, 02/2015, A5E03775306-AC
3.2 Normes et homologations du répartiteur de terrain actif AFD4 (FM)
Exigences concernant
Emission de perturbations
EN 61000-6-4: 2007
Caractéristiques techniques
Immunité aux perturbations
EN 61000-6-2: 2005
35
Publicité
Table des Matières
