emerio CBC-12434.1 Mode D'emploi page 12

Attention (1):
The timer settings which you make under "01" (executed only once) should be made for the current week. On
Sunday (day 7) at 24:00, all "01" settings will be set to "non-activated". Therefore, a timer setting for Saturday
that you made on Tuesday will work, but a timer setting for Tuesday that you make on Saturday will not work!
Attention (2):
If a timer setting with number 01 was made for this day, you must manually set the next timer setting for this
day to 02 using the button "+". Otherwise the timer setting 01 will be overwritten.
Attention (3):
Start & stop times can only be set in whole hours (not in minutes).
Note:

If the appliance is switched off by using the power switch or by removing the plug from the electrical
outlet, the day will be set to 01 and the time will count from 00 (hour) and 00 (minute) for the next time
you switch the appliance on again. However, the timers that were set previously are still stored. Therefore,
to avoid misunderstandings, the weekly timer function will be automatically set to OFF ("OF" shown in LED
display) in case of turning the heater off using the power switch or removing the plug from the socket.
Otherwise, the heater would switch on and off at the wrong times. Make sure to reset the current day and
time once turn on the appliance again and remember to set the weekly timer function to ON ("ON" shown
in the LED display) as described in above table.

During the timer setting, if no button is pressed for approx. 10 seconds, the timer setting will stop and you
will have to start all over again.

All timer settings – maximum 28 settings: seven (7) days multiplied by maximum four (4) settings per day –
are processed consecutively. Therefore, make sure that they do NOT contain contradictions.
2. Cancel the timer settings
1) Cancel all the timer settings.
Press the button "WEEK" for approx. 3 seconds until the LED display shows the flashing "UU".
Long press the button "C" until a beep sound is heard. It means all the timer settings are cancelled.
2) Cancel all timer settings of a specific day.
Press the button "WEEK" for approx. 3 seconds until the LED display shows the flashing "UU".
Press the button "SET" consecutively until the LED display shows the flashing "U1" (day 1, for
example).
Press the button "+" / "-" to select the day for which you want to cancel the timer settings.
Long press the button "C" until a beep sound is heard. It means all the timer settings of the day are
cancelled.
3) Cancel a specific timer setting.
Press the button "WEEK" for approx. 3 seconds until the LED display shows the flashing "UU".
Press the button "SET" consecutively until the LED display shows the flashing "U1" (day 1, for
example).
Press the button "+" / "-" to select the day for which you want to cancel the timer setting.
Press the button "ED".
Press the button "+" / "-" to select the number of the timer setting that you want to cancel.
Long press the button "C" until a beep sound is heard. It means this timer setting is cancelled.
- 11 -