emerio CBC-12434.1 Mode D'emploi page 9

Please install the wall mounting bracket by following steps.
1. Choose a firm, even, vertical wall made of heat-resistant material on which to hang the appliance.
2. Define the position of the wall mounting bracket: the bracket should be mounted horizontal to the wall.
Position the bracket in such a manner that the minimum distances stated in fig.1 are guaranteed after the
appliance is mounted to the wall. Mount the bracket with the correct side upwards (see the mark "This
side up" on the bracket).
3. Mark the positions of the four holes to be drilled on the wall.
4. Drill 10mm holes in the marked places.
5. Insert the bolts (A&B) into the holes with a hammer. Put on the wall bracket. Secure the wall bracket
immovably against the wall by using the washer (C), gasket (D) and nut (E).
6. Hang the panel by letting the knobs through the eyes in the wall mounting bracket. Slide the panel as far as
possible to the right side and lower it as far as possible. Now the panel is mounted securely.
7. To remove the panel from the wall, you must lift and slide in the opposite direction, until the knobs are in
front of the eyes again. Now you can take the panel off.
Note: Guide the electric cable immediately downwards and make sure that it does not come into contact with
the panel. Do not conceal the cable behind the heater!

Holes

Bolts

Wall mounting bracket
- 8 -