emerio CBC-12434.1 Mode D'emploi page 10

OPERATION
Plug the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch to
position "I". The power indicator light will be illuminated on the LED display. The appliance is standby.
You can use the control panel on the appliance or the separate remote control to operate your appliance.
Please note the control panel can only operate the basic functions. The remote control can operate the basic
functions as well as the advanced functions.
The remote control should be directed towards the LED display while using.
Basic functions:
1. Press the on/off button to turn on the appliance. Press the button again to turn the appliance off.
2. Set the temperature.
1) Press the button " + " or " - " to set your desired temperature. You can choose from 0-37℃. Long
pressing for rapid adjustment.
2) The LED display will flash the set temperature approx. 10 seconds and then turn back to show the
current temperature. It means the temperature has been set.
3) If the set temperature is higher than the current temperature, the appliance will start to heat and the
heating symbol will be illuminated on the LED display. If the set temperature is reached, the appliance
will automatically switch off and then switch on again when the room cools down. The heating symbol
will be off and illuminated again accordingly.
Note: If no button is pressed in approx. two minutes, the current temperature will disappear from the LED
display. Pressing any button will make the current temperature re-appear.
3. Set the current day and time (so that you can set the weekly timer function later.)
1) Let the appliance be on but not heat. Therefore, no heating symbol is illuminated on the LED display.
(Do this by setting the temperature lower than the current temperature, for example.)
2) Follow below steps in the table to set the current day and time. When using the control panel, please
press the button "M". When using the remote control, please press the button "SET".
Step Press button
1 M / SET (3 sec.)
2 + or –
3 M / SET
4 + or –
5 M / SET
6 + or –
7 M / SET
4. Check the current day and time.
1) Let the appliance be on and heat. Therefore, the heating symbol is illuminated on the LED display. (Do
this by setting the temperature higher than the current temperature, for example.)
2) Consecutively press the button "M" (on the control panel) / "SET" (on the remote control) to check the
current day and time:
HH: day of the week;
H1: hour;
H2: minute.
The LED display shows
HH flashes
01 to 07
H1 flashes
00 to 23
H2 flashes
00 to 59
Current temperature
- 9 -
It means to set the day of today.
01 = Monday, 02 = Tuesday, 03 = Wednesday, 04 =
Thursday, 05 = Friday, 06 = Saturday, 07 = Sunday.
It means to set the current hour.
Choose the correct hour.
It means to set the current minute.
Choose the correct minute.
It means the day and time are set.
Note