emerio CBC-12434.1 Mode D'emploi page 8

Remote control
1. On/off button
2. Cancel button
3. Open-window detection button
4. Set button
5. Ok button
6. Edit button
7. ECO button
8. Temperature button
9. Time on button
10. Time off button
11. Value increase button
12. Value decrease button
13. Week button
WALL MOUNTING
The fixing materials supplied are intended for a brick wall. If you are using a different type of surface, you
should supply appropriate fixing materials yourself.
This heater has been designed to hang securely from the wall. Do not use it until it has been properly
installed, as described in these instructions for use and never, for example, in a standing position or when
leaning against something!
Please take below minimum distance picture (fig.1) for reference.
A
B
(fig.1) (fig.2)
Please pay attention to fig.2: The wall-mounting system (A & B) on the rear side of the appliance should be
pre-mounted in order to hang it vertically. Viewed from the front, the power switch is at the bottom side and
the control panel is at the right-hand side.
A. Wall mounting bracket & knobs
B. Wall spacer (Bracket for keeping space from the appliance to the wall)
Note: The knobs and wall spacer have already been installed on the rear side by the factory.
- 7 -