Description - Shindaiwa EB2510 Manuel D'utilisation

1. Spark plug Provides spark to ignite fuel mixture.
2. Starter handle Pull recoil handle slowly until recoil starter
engages, then quickly and firmly. When engine starts,
return handle slowly. DO NOT let handle snap back or
damage to unit will occur.
3. Air cleaner Contains replaceable air filter element.
4. Choke Choke is located on left side of the air cleaner.
Move choke lever to
starting. Move choke lever to
choke.
5. Purge bulb Pumping purge bulb before starting engine
draws fresh fuel from the fuel tank, purging air from the
carburettor. Pump purge bulb until fuel is visible and
flows freely in the clear fuel tank return line. Pump
purge bulb an additional 4 or 5 times.
6. Fuel tank cap Covers and seals fuel tank.
7. Fuel tank Contains fuel and fuel filter.
position to close choke for cold
position to open

Description

8. Spark arrestor - Catalytic silencer / Silencer The si-
lencer or catalytic silencer controls exhaust noise and
emission. The spark arrestor screen prevents hot, glow-
ing particles of carbon from leaving the silencer. Keep
exhaust area clear of flammable debris.
9. Throttle limiter lever For reduced noise setting.
10. Throttle trigger Spring loaded to return to idle when re-
leased. During acceleration, press trigger gradually for
best operating technique.
11. Blower pipes Exclusive positive locking system.
12. Ignition switch "SLIDE SWITCH" mounted on top of
handle. Push forward to start and run. Slide back to
stop.
13. Throttle position lever Pull back to increase engine
speed. Friction washers maintain throttle lever setting.
14. Serial number label Lists model number and serial
number of unit.
15. Housing cover Covers blade area.
13
Description