Mounting Of Caller Unit - Renkforce 1168614 Notice D'emploi

• Press and hold the Power ON/OFF
the batteries from the caller unit and then reinsert them or connect the caller unit to
a 12 V supply. The system is now ready for operation.
• If the pairing process is not successful ( the letter
display of the handset), repeat the whole pairing process.
In case you are having two or more handsets and a caller unit, always set all
handsets to the pairing mode first and perform the pairing process with the
caller unit and handsets together.
Whenever you add new units (handset) to the system, it is necessary
to perform the pairing process all over again with all the units together.
Otherwise, the new units will not work with your original system.
You can only purchase complete sets consisting of one handset unit and one
caller unit. Both units are not available separately.
c) Mounting of caller unit
• Select an installation location near your door entrance with a smooth surface.
Do not install the wall bracket on a metal surface or in the vicinity of other electronic
devices that may reduce the range. Install the wall bracket directly onto the wall.
Drilled holes
button (14) to switch off the handset. Take out
Insert dowels into holes
(dependent on the
condition of the wall).
continues to flash on the LC
45