Renkforce 1168614 Notice D'emploi page 36

• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low
height can damage the product.
• Also observe the safety and operating instructions of any other devices
which are connected to the product.
• As power supply, only use the supplied mains adaptor.
• The mains outlet must be located near to the device and be easily
accessible.
• Only connect the power adaptor to a normal mains socket connected to
the public supply. Before plugging in the power adaptor, check whether
the voltage stated on the power adaptor complies with the voltage of your
electricity supplier.
• Never connect or disconnect the power adaptor if your hands are wet.
• Never unplug the power adaptor from the mains socket by pulling on the
cable; always use the grips on the plug.
• When setting up the product, make sure that the cable is not pinched,
kinked or damaged by sharp edges.
• Always lay the cables so that nobody can trip over or become entangled in
them. This poses a risk of injury.
• For safety reasons, disconnect the power adaptor from the mains socket
during storms.
• For safety and licensing reasons, unauthorised conversion and/or
modifications to the product are not permitted. Never open/dismantle this
product!
36