Safety Notes; Important Notes; Functions; Spare Parts - Minitrix BB 22200 Serie Mode D'emploi

Safety Notes

• This locomotive is to be used only with an operating
system designed for it.
• This locomotive must never be supplied with power from
more than one power pack.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The wire used for feeder connections to the track may
only be a maximum of 2 meters / 78 inches long.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
14972 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• Analog 14 volts DC, digital 19 volts AC.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or

spare parts.

• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• Trix locomotives can be operated on all 2-rail DC systems
with conventional DC power packs.
• An electronic overload protection is build in to protect the
model.
• Dual headlights in the front, dual red marker lights in the
rear, that change over with the direction of travel.
• Trix motor vehicles must not be operated on digital
systems without an built in engine decoder (Motor can be
damaged!).
• Based on the NEM 661 standard, the speed of the loco-
motive at 12 volts is set approximately at the maximum
speed for the prototype.
• NEM close coupler mechanism and coupler pocket.
• Locomotive with a 14-pin digital connector.
• The light function can be changed by plugging
the bridge plug in the opposite way.
Double „A": switching light
LV+LR: headlight changeover front and rear
LV: headlight changeover only front
LR: headlight changeover only rear
5