Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Range Hood
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Using two or more people, lift the hood liner into the cabinet
until it snaps into the 4 hooks located on the mounting
brackets. The hood liner will remain suspended.
2. Attach the 4.2 x 8 mm (8) screws into the slotted openings.
Do not tighten screws.
A
A. Cabinet
B. Hood liner canopy assembly
3. Center the canopy in the cabinet. Align the bottom of
the canopy with the bottom of the cabinet. Install the
4.2 x 8 mm T20
screws into the mounting bracket
®
and tighten all mounting screws.
4. Place the lower canopy assembly in the front side of the
cabinet and slide it through the bracket as shown in drawing.
12
B
C
C. Screws - 4.2 x 8 mm (8)
5. Open perimetric panel and remove the metal grease filters
from the lower canopy assembly.
6. Secure the lower canopy assembly to the hood using the
4 x 15 mm and the 4.5 x 13 mm screws as depicted
in the diagram below to fasten the panel. Tighten to secure.
B
A. Screws - 4 x 15 mm (4)
B. Screws - 4.5 x 13 mm (3)
7. Plug lamps and control wire connectors from the lower
canopy assembly into the connectors located inside the
hood liner.
A
B
A. Control wire
B. Motor box wire
A
A
B
A. Lamp wire
B. Motor box wire
Publicité
Table des Matières
