Range Hood Care; Cleaning - Whirlpool LIB0131212B Instructions D'installation Et Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleaning

IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter
before operating hood.
Exterior Surfaces:
IMPORTANT: To avoid damage to the exterior surface, do not
use steel wool or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
All purpose cleaner.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Grease Filter
1. Open the panel. Grasp panel at the front corners and pull
down to disengage the two catch pins from the spring
catches. The panel is attached at the rear and will rotate
down.
A
B
A. Metal filters
B. Stainless steel panel
C. Catch pins (2)
D. Spring catches (2)
2. Remove each filter by pulling the spring-release handle and
then pulling down the filter.
A
A. Spring-release handle
3. Wash metal filter as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by making sure the spring-release handles
are toward the front. Insert metal grease filter into upper
track.
5. Pull the spring release handle down.
6. Push up on metal filter and release handle to latch into place.
7. Repeat steps 1-5 for the other filter.
8. Close the panel. Engage the two pins in the spring catches
to secure.

RANGE HOOD CARE

D
C
Non-Vented (recirculating) Installation Filters:
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
"Accessories" section for information on ordering.
To replace charcoal filter:
1. Cover the grille that covers the blower motor with the
charcoal filter so that the slots on the filter correspond to the
pins on the sides of the motor grille.
A
B
A. Charcoal filter
B. Pins
C. Blower motor
2. Turn the charcoal filter clockwise to lock it.
3. Repeat steps 1-2 on the other filter.
Replacing an LED Lamp
The LED lights are replaceable by a service technician only.
See the "Assistance and Service" section for service contact
information.
C
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

W11468698a

Table des Matières