Whirlpool LIB0131212B Instructions D'installation Et Guide D'utilisation Et D'entretien page 9

Cabinet Height
15" (38.1 cm)
A
A. Cutout
B. Ø 6¼" (15.9 cm)*
Cabinet Height
18" (45.7 cm) or
24" (61.0 cm)
For non-vented (recirculating) installations only, the range hood
can be vented indoors through the top of the cabinet.
For non-vented (recirculating) installations, charcoal filters are
necessary. See the "Range Hood Care" section for instructions
on installing charcoal filters. The Recirculation Kit must be used.
See the "Assistance or Service" section to order.
Venting Outside Through the Wall
1. Install transition on top of hood (if removed for shipping) with
two 3.5 x 9.5 mm sheet metal screws.
A. Vent transition
B. 3.5 x 9.5 mm screws
Hole Shape and Size
A 6¼" (15.9 cm) diameter round
opening is required.
C
B*
D
C. 7 ⁄ " (19 cm) centerline to
1
2
cabinet front
D. Centerline
Hole Shape and Size
A 5¾" (14.6 cm) diameter round
opening is required.
B
A
2. Assemble the vent duct that you will use over the
6" (15.2 cm) vent transition. Measure from the bottom
of the range hood liner to the horizontal centerline of the
vent opening (A).
B
A
A. Measurement A
B. Horizontal centerline of vent
opening
C. Range hood liner
3. Remove the vent duct from the range hood liner.
Transfer measurement A to the cabinet back wall. Measure
from the underside of the cabinet.
4. Mark the cutout as shown. Use a saber saw or keyhole saw
to cut a round opening through the top of the cabinet and
the exterior wall for the vent.
A
B
A. Measurement A
B. Centerline
C. 6¼" (15.9 cm) round
cutout
C
C
9