MATERIALS
A
1
Main Crossbar.
C
2
Side arms.
D
2
M12 x 35 x 1.75 bolts, lock washer, 40 O/D washer and cage nut assembly.
E
2
M12 x 35 x 1.75 bolts, Nyloc nuts and 40 O/D washers.
F
2
M12 x 35 x 1.75 bolts and Nyloc nuts.
ZE
1
Electrical Plate.
ZN
1
Neck option.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball, which
dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
FITTING
1.
Skoda bumper removal remove 4 off fixings in wheel arches each side and fixings along the lower edge of the bumper.
2.
Remove plastic covers at rear lights to reveal 2 off fixings, remove fixings and rear light clusters.
3.
Remove bumper by pulling wheel arc edge toward bumper clips under light clusters, disconnect reversing sensors if
fitted.
4.
Remove crash beam and hand to customer, (Passenger Side) unbolt rearmost exhaust hanger to lower exhaust, lower
or remove heat shield to reveal mounting holes. Remove tapes from mounting holes.
5.
Audi Bumper removal remove wheel arch fixings on both sides, remove fixings along lower edge of bumper.
6.
Remove 4 off hidden fixings across the rear of the vehicle, 2 behind rubber grommets accessed from inside vehicle on
back panel, 2 fixings one each side of vehicle in corner below light clusters, Note: be careful not to lose the nuts inside
rear panel. remove plastic pin each side from below removed light clusters. Pull bumper rearward disconnecting any fitted
parking sensors. Remove tapes covering the towbar mounting holes.
Both vehicles loosely fit side arms "C" using correct configuration of holes (see illustration below ) Attach part "A"
7.
using fixings "F".
8.
Attach chosen neck option and fit electrical plate.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
Fitting
Instructions
W 0 0 0 1 S K 3 0 U - F IT $ 0 1 0 8 0 2 2 2 0 0 0 0
AUDI A3 SALOON 2013-
#NAME?
TOWBAR
For SKODA SCOUT
SK30