Witter SK18BU Notice De Montage

MATERIALS
A 1 Cross Bar.
C 1 RH Sidearm.
D 1 LH Sidearm.
G 4 M12 x 45 x 1.75 bolts, lock washers, flat washers (40o.d.), Witter square nuts and retainers.
H 4 M12 x 35 x 1.75 bolts with M12 flange nuts.
EP 1 Electric plate.
ZX 1 Detachable kit
FITTING FOR AUDI & SKODA HATCH & ESTATE
1. Remove bumper (5 screws on lower edge, 2 screws beneath light cluster (remove light clusters), 1 screw inside boot
beneath light cluster, 1 plastic pin in centre of bumper on boot shut panel, 3 screws and 1 push in clip around wheel arch.)
Slide bumper backwards off side panel sliders.
FOR SCOUT
1. Remove bumper (5 screws on lower edge, 2 screws beneath light cluster (remove light clusters), 2 screws behind side
panels, 3 screws and 1 push in clip around wheel arch.).
2. Remove the rearmost exhaust hanger and heat shied to allow access to side mountings.
3. Remove crash beam and hand to end user for re-fitment when bar is removed. Refit bolts to rear panel to prevent
ingress of water.
4. Insert Caged Nuts into the Side Arms C & D (Use Cage Nut installation guide to assist with fitment). Loosely attach Side
Arms to existing side mountings inside the chassis (may have to remove tape covering holes) using fixtures G
5. Attach Cross Bar (A) using fixtures H to the Side Arms. Fully Tighten Bolts to recommended settings.
6. Locate centre of bumper and cut as shown below. (No bumper cut required on VRS OR SCOUT )
7. Please refer to ZQ fitting instruction for fitting of ZQ detachable unit and attach Electrical Plate (EP).
8. Refit Bumper, exhaust heat shield etc..
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M10 - 53 Nm, M12 - 75 Nm, M16 - 214 Nm
ZX
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY Tel: 01244 284500 Fax: 01244 284577
Fitting
Instructions
µW0001SK18BU-FIT$011208010000lÄ
W0001SK18BU-FIT$011208010000
TOWBAR for AUDI SPORTBACK
SKODA OCTAVIA HATCH / ESTATE
SKODA SCOUT
SK18BU
FEB 2005-
Inc VRS
Issue 1