Witter SK19BU Instructions De Montage

MATERIALS
A 1 Cross Bar.
C 1 RH Sidearm.
D 1 LH Sidearm.
G 4 M12 x 45 x 1.75 bolts, lock washers, flat washers (40o.d.), Witter square nuts and retainers.
H 4 M12 x 35 x 1.75 bolts with M12 flange nuts.
EP 1 Electrical Plate
ZX 1 Chosen Neck (series ZF3013A)
FITTING
1. Remove bumper (5 screws on lower edge, 2 screws beneath light cluster (remove light clusters), 2 screws behind side
panels, 3 screws and 1 push in clip around wheel arch.).
2. Remove the rearmost exhaust hanger and heat shied to allow access to side mountings.
3. Remove crash beam and hand back to end user. Refit bolts to prevent ingress of water.
4. Insert cage nuts into the Side Arms C & D (Use Cage Nut installation guide to assist with fitment). Loosely attach Side
Arms to existing side mountings inside the chassis (may have to remove tape covering holes) using fixtures G
5. Attach Cross Bar (A) using fixtures H to the Side Arms. Fully tighten bolts to recommended settings.
6. Please refer to fitting instructions to attached chosen neck (ZX) and Electrical plate (EP).
7. Refit Bumper, exhaust heat shield etc
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M10 - 53Nm, M12 - 75Nm, Grade 10.9 M12 – 139 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY witter-towbars.co.uk
Fitting
Instructions
µW0001SK19BU-FIT$021208030000PÄ
W0001SK19BU-FIT$021208030000
TOWBAR
SK19BU
For Skoda Octavia
Scout
Issue 1