R&G CP0276 Instructions De Montage page 3

TOWARDS REAR
OF BIKE
Left-hand side (as you sit on bike)

Remove Honda accessory belly/side fairing.

Remove engine bolt in position arrowed in picture ONE (ensure frame too engine spacer remains
in place). Please note the upper fairing-mounting bracket will have to be removed.

Engage marking tool in the engine mounting hole and using spanner flats tighten until
approximately 38mm to point of tool is protruding from frame bracket.

Refit fairing without the upper fairing-mounting bracket.

Gently tap fairing with the palm of your hand to mark the inside of the fairing.

Remove the fairing panel and drill a pilot hole on the mark left by the marking tool.

Offer the fairing back up to the bike to check the hole position.

When happy that hole is in the right position use a 28mm hole saw and drill through from the
outside to inside. Do not refit fairing at this stage.

Refit the original engine-mounting bolt and tighten.
Right-hand side (as you sit on bike)

Remove Honda accessory belly/side fairing.

Remove engine bolt in position arrowed in picture TWO (ensure frame too engine spacer remains
in place). Please note the upper fairing-mounting bracket will have to be removed.

Engage marking tool in the engine mounting hole and using spanner flats tighten until
approximately 20mm to point of tool is protruding from frame bracket.

Refit fairing without the upper fairing-mounting bracket.

Gently tap fairing with the palm of your hand to mark the inside of the fairing.

Remove the fairing panel and drill a pilot hole on the mark left by the marking tool.

Offer the fairing back up to the bike to check the hole position.

When happy that hole is in the right position use a 28mm hole saw and drill through from the
outside to inside.

Remove the marking tool.

Refit the fairing panel and the upper fairing-mounting bracket.

Take the M12x110 mm long bolt and slide one of the plain washers up to the head of the bolt.

Take one of the shake proof washers and slide over the bolt up to the other washer.

Install bolt through one of the protectors and slide the shorter spacer (S0345) up to the protector.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE THREE
R&G Racing
www.rg-racing.com
TOWARDS FRONT
OF BIKE
Email: info@rg-racing.com