Magmaweld SMART Serie Mode D'emploi page 24

24 Operation
Wire type is selected. The type of wire to be used must be selected correctly. Each press of the button enables
EN
4-) WIRE TYPE SELECTION
a transition between the lines in the relevant column. When the wire type is selected, the corresponding led
will light.
• Steel
Setting Range
• FCW
• FCW-M
• CrNi
Wire diameter is selected. The wire diameter to be used must be selected correctly. Each press of the button
5-) WIRE DIAMETER SELECTION
enables a transition between the lines in the relevant column. When the wire type is selected,
the corresponding led will light.
• 0.6 - 2.4 mm
Setting Range
Gas type is selected. The type of gas to be used must be selected correctly. Each press of the button enables
6-) GAS TYPE SELECTION
a transition between the lines in the relevant column. When the wire type is selected, the corresponding led
will light.
• CO2
Setting Range
• Ar/15-25 CO2
• Ar/10-15 CO2
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• AlMg
• AlSi
• CuSi
• CuAl
• Ar/5-10 CO2
• Ar/2.5 C02
• Argon
SMART SERIES / SMART SERİSİ
www.magmaweld.com