Information And Settings; Displaying Information; Displaying Settings - Siemens TK76K573 Mode D'emploi

de en

Information and settings

Use i (7) to display information (press
briefly) and adjust settings (hold down for at
least three seconds).

Displaying information

In the Info menu (press
can call up the following information:
► when it is necessary to descale the
appliance
► when it is necessary to clean the
appliance
► when it is necessary to change the filter
► how much coffee has been dispensed
since the appliance was first put into
operation
► how many milk drinks have been
dispensed
► how much hot water has been prepared
Information / Service
....................................................................................
Descale after

Displaying settings

Hold down i (7) for at least 3 seconds;
the different setting options are then
displayed:
Default settings
Language:
English
Use and
<
the different setting options. The currently
active setting is always highlighted in white.
You can change the setting that is currently
displayed by turning the rotary knob
To exit the menu, press
44
(7) briefly) you
i
100 cups
Per-cup quantities
(3) to switch between
>
i (7) again.
The changes you have made
are saved automatically. It is
not necessary to confirm them
additionally.
The following setting options are available
to you:
> Language
select the display language.
> Per-cup quantities
quantity can be set separately for each
type of drink and each cup size (see "Set
per-cup quantity" on page 45).
> Water hardness
(4) to select the required water hardness
(1, 2, 3 or 4) (refer also to "Checking and
setting the water hardness").
> Coffee temperature
(4) to set the coffee temperature.
> Auto off after
(4) to enter the time span after which the
appliance should automatically switch off
following the last drink preparation.. A time
between 5 minutes and 8 hours can be set.
The default time is one hour, but this can be
shortened to save energy.
> Contrast
be set from –20 to +20 with the rotary knob
(4). The default setting is 0.
> Illumination
set to ,
Off
setting: On
> Water filter
filter is inserted in the water tank (12), it
must be rinsed:
1. Place the water filter in the water tank
(12) and fill the tank with water up to the
"max" mark.
2. Turn the rotary knob
Press start
(8).
3. Place a container with a capacity of
0.5 litres under the milk frother (10).
4. Press
(4). run first through the filter to rinse it and
then into the container.
: Turn the knob
: The per-cup
: Turn the knob
: Turn the knob
: Turn the knob
: The display contrast can
: The lighting can be
or
On Off after 5 min.
).
: Each time a new water
(4) to select
and press
start stop (8). Water will now
(4) to
(factory
start stop