Velux KLI 110 Instructions page 29

ENGLISH: Removing/adding electrical products connected to con-
trol unit KLC 500 from/to control keypad KLI 110
Disconnect all electrical products and reconnect only products to be
1
removed/added to control keypad KLI 110.
Remove/add control and transmit functions by pressing PRG button
2
in keypad for max 2 seconds. This procedure can take up to 2 min-
utes. LED flashes green slowly.
Remove cover from control unit. When LED in keypad flashes green
3
quickly, press test button in control unit for max 5 seconds to receive
system in the control unit and to transmit function of control unit.
When the first electrical product s'active brièvement dans un mouve-
4
ment de va-et-vient, configure the product(s) in the keypad by press-
ing any operation key for max 2 seconds. LED flashes green slowly for
a few seconds.
The product can now be controlled by control keypad KLI 110.
When configuration has been completed, LED is green for 4 seconds.
If configuration has failed, LED is red for 4 seconds.
Note: For electrical products controlled by a remote control KLR 100,
please refer to the user manual for KLR 100.
VELUX 29