Velux KLI 110 Instructions page 21

ENGLISH: Configuring control keypad KLI 110 to control electrical
products connected to control unit KLC 500
Disconnect all products that are not to be controlled by control
1
keypad KLI 110 from control unit KLC 500.
Note: In case of new electrical products, complete item 2 within 10
minutes from reconnection.
Transmit system from keypad by pressing the PRG button for max 2
2
seconds. Transmission can take up to 2 minutes. LED flashes green
slowly.
Remove cover from control unit. When LED in keypad flashes green
3
quickly, press test button in control unit for max 5 seconds to receive
system from keypad in the control unit and to transmit functions of
control unit.
When the first electrical product runs briefly back and forth, config-
4
ure the product(s) in the keypad by pressing any operation key for
max 2 seconds. LED flashes green slowly for a few seconds.
When configuration has been completed, LED is green for 4 seconds.
If configuration has failed, LED is red for 4 seconds.
VELUX 21