Instructions for installation and use
1. About this instruction manual
Read these installation and operating instructions carefully and keep them within
reach of the infrared cabin. This ensures that you can refer to information on
safety and operation at any time.
These installation and operating instructions can also be found in
the downloads section of our website: www.sentiotec.com/downloads.
2. Important information for your safety
The infrared cabin has been produced in accordance with the applicable safety
regulations for technical units. However, hazards may arise during use. Therefore
adhere to the following safety information and the specific warning notices in the
individual chapters.
2.1. Intended use
The infrared cabin is used for the heating of the human body.
The cabin location must be protected against splashing water. For optimal
operation, the location should have an ambient temperature of at least 20 °C.
The maximum air humidity in the surroundings should not exceed 95%.
The cabin must be erected on a level surface. A distance of at least 5 cm from
the wall must be maintained.
Any use exceeding this scope is considered improper use. Improper use can
result in damage to the product, severe injuries or death.
p. 3/10
EN