Siemens Profiset 3010 Manuel D'utilisateur page 5

Table des Matières

Publicité

REDIAL key
All manuals and user guides at all-guides.com
In order to redial the last number dialed, lift
the handset and press the REDIAL key
If the last number dialed contains more
than 32 digits, the REDIAL function will not
work properly.
MUTE key
When you press the MUTE key
call, the microphone is switched off and the
other party cannot hear you. To resume a
normal conversation, press the MUTE key
again. While MUTE is enabled, the other
party will hear music on hold (MOH). If
necessary, MOH can be disabled. When
MOH is disabled, you will be able hear the
other party whereas the other party will not
be able to hear you.
Enabling MOH:
Lift the handset
Press the PROG key
: Enter the code 1101
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
Disabling MOH:
Lift the handset
Press the PROG key
: Enter the code 1100
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
PAUSE key
This key can be used when the telephone
is connected to a PBX system. It inserts an
.
interdigit
seconds, starting with the first digit when
you press the PAUSE key
pauses
memories, two-touch memories or on the
REDIAL key
during a
FLASH key
The FLASH key
number of special features (follow-me, call
waiting, conference, etc.) provided your
telephone is connected to a digital Central
Office or to a PBX system.
The default factory flash is 270 ms. It may
be necessary to program a different flash
time. If you have problems using the flash
key, refer to the documentation of your PBX
to determine the recommended flash time.
Changing the flash time:
To change the programmed flash time,
proceed as follows:
Lift the handset
Press the PROG key
Enter one of the codes below,
depending on the desired flash time:
:
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
4
pause
of
approximately
can
be
stored
.
(special features)
allows you to use a
• 1950 for 90 ms flash time
• 1951 for 120 ms flash time
• 1952 for 270 ms flash time
• 1953 for 375 ms flash time
• 1954 for 600 ms flash time
3.6
. These
in
one-touch

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hipath 1100

Table des Matières