Luvion ICON CLEAR 75 PRO Manuel D'instructions page 16

16
for at least a second. If you're resetting the Parent unit, Reset should show on
your display screen.
You should only reset if you're having problems with your baby monitor.
TROUBLESHOOTING
Troubleshooting
Why is the Parent unit beeping?
Why isn't the Link light coming on?
Why aren't the units linking?
What do I do if the battery is showing as low on the
Parent unit?
Why is my Parent unit very quiet?
Why is there a high-pitched noise coming out of one
of the units?
Why isn't talkback working
Take a look at 3.28 for a list of the tones the Parent
unit makes. It could be beeping for a few diff erent
reasons.
• The link has been lost between your units.
Check that the Baby unit Link indicator is illu-
minated. If not, make sure the power adapter
is still connected.
• The feed timer has been set. See 3.19.
• The temperature alert has been triggered. See
3.23
• The batteries are low. See 1.2. If the Parent unit
still beeps after this, try switching the Baby
unit off at the mains power socket and remov-
ing the batteries for around 30 minutes. Make
sure the Parent unit is clean by wiping with a
damp cloth. If this doesn't work, contact Luvion
customer service.
• Check that both units are switched on.
• Check the batteries in the Parent unit are in-
stalled properly and charged.
• Check that the mains power is plugged in and
switched on at the Baby unit.
• Check that the units are within range of each
other.
• Make sure the units are within range of one
another.
• Check if both units are turned on.
• Plug the unit into a wall power socket to
charge it. It's best to leave the unit plugged in
whenever you can, to make sure the batteries
are always charged.
• To fully charge the batteries, the Parent unit
should be on charge for about 16 hours if
switched off and 24 hours if switched on.
• To speed things up, turn the Parent unit off
when charging if it's not being used.
• You may have set the volume too low. See 3.4.
• You may have switched Mute on. Take a look
at 3.4.
• The units might be too close to each other.
• The volume setting might be too high.
• Check that the volume is loud enough at the
Baby unit.
• Check the units are linked.