Backlight - Luvion ICON CLEAR 75 PRO Manuel D'instructions

LUVION
thermometer or thermostat in your house, you can adjust the one on your monitor to
match.
1.
On your Parent unit, press
2.
When you see "Temperature", press
3.
Press until "Adjust temp?" shows on the screen and press
4.
Then use the arrow buttons to add the temperature you want to change to and
press
Pre-set temperature alert range: The Baby unit comes with pre-set maximum and
minimum temperatures. If the temperature falls below or goes above the set range, an
alert will sound on the Parent unit and the display will show Too Cold or Too Hot.
3.26 Resetting the temperature on your monitor
If you've adjusted the temperature on your monitor, you can reset it through the Parent
unit.
1.
Go into the main menu and press
2.
When you see "Temperature" , press
3.
Use the arrow buttons again to scroll through to "Reset Temp". Press
4.
When it shows the temperature you want, press
you'll hear a confi rmation beep.
3.27

Backlight

You can select whether the backlight comes on when you get an alert on your Parent
unit. The default setting is On and the screen will remain lit up for 15 seconds.
1.
Press
2.
Press
3.
Use the
press
3.28 List of tones
Your baby monitor can produce various tones. They have the following meaning:
TONE
Single tone
Fast double tone
Slow double tone
Fast triple tone
You can turn off user alert tones by pressing any button on the Parent unit.
To switch off system alerts for fi ve-minutes, press any button on the Parent unit.
3.29 Resetting the units
Resetting either units means they'll return to the settings they came with.
1.
Make sure the unit you're resetting is switched off .
2.
Switch it back on again by pressing and holding the
3.
Within four seconds of turning the power back on, press and hold the
Premium Baby products
, then use the arrow buttons to get to "Setup". Press
to save.
and then use the arrow buttons to scroll through to "Setup". Press
to get to "Backlight" and press
and buttons to choose between "On w alerts" or "Off w alerts", then
to save your choice.
.
until you get to "Setup". Then press
.
. "Saved" will be displayed and
.
MEANING
Confi rmation (for example, saving a setting).
Error (for example, trying to change the
volume but already reached maximum).
User alert (for example, time to feed
your baby.
System alert (for example, link lost or
battery low).
button down .
.
.
.
.
button
15
EN